I have a Windows 7 Desktop that I want to use a mic. I connected the mic to the pink input jack (mic in). But the volume is too soft. When I enter the properties menu, I see something like this:What is the difference between the Microphone and Microphone Boost? How do I determine the optimal setting?In addition, there is another Control Panel tool which is related to microphone setup. It makes me read a sentence 'Peter dictates to his computer. Blah blah blah'.
Studio Microphone
While there is a decrease on contrast ratio of Sony X900F to the predecessor, in term of peak luminance, there is a bit improvement over X900E. While peak brightness reached by Sony X900E is still lower than 900 nits, peak brightness reached by X900F is almost close 1000 nits. Condenser vs Dynamic Microphone Condenser microphone and dynamic microphone are two types of microphones, which are commonly used. Dynamic microphones are made based on the electromagnetic induction whereas condenser microphones are based on the operation of a capacitor (condenser). Both of these devices are very important in fields such as audio engineering, acoustics, data.
After that, it says it did not hear anything even though I clearly see the volume changes as I read. I read it again and it then told me my microphone is now set up! What does it really do? I don't have a technical answer for you, but I can share my experience when testing different combinations of the two. I've found that the Boost level does a good job of making the microphone sound very close to me, when I move it further away - whereas the Volume becomes audibly 'distant' and quiet when it's moved away, and the alternative to turn it up, which literally picks up all the noise it senses, including background fuzz. Put the Volume too high and voices will begin to sound 'tinny'.You can turn the Volume down then, but move the Boost up, and you will get a louder voice without that effect.
Best Condenser Mic Under 1000
Bear in mind that Boost will still pick up background noise to some extent, so trial and error is what's needed.